901 atomizer help for new bie

[zelda]

My 901 atomizer stopped working. and I noticed 2 wires on the top one on each side (not touching). Should they be?

Just trying to figure why it wont work - it doesn't heat up at all.

Any help appreciated!

 

[Scottbee]

Two wires on the top? There shouldn't be any exposed wires at all.

Sounds to me like you might be talking about the metal mesh that is supposed to be over the top of the "bridge". If that is broken in half... that atty is ruined.

This may have been caused by twisting the cartridge to put it on or take it off. Don't do that. ;-)

 

[zelda]

The bridge is ok. The atomizer is in a casing and came out.
There are 2 wires at the top where the battery connects.

 

[Shreck]

sounds like you pulled the insides of the atty right out of the tube?
If so (this has happened to me before) if the wires are still connected to the battery connector at one end, and go into the attys shell, or "pot". I can usually put it back into the tube gently and it works fine. But if any wires are broken it isnt going to work.. If they are not broken and the atty doesnt work then you have another problem, probably near the atty coil itself, which is under the bridge.
Of course, this may not be what you are talking about at all, and if so, just disregard anything I have said, LOL!!

 

[Scottbee]

The bridge is ok. The atomizer is in a casing and came out.
There are 2 wires at the top where the battery connects.

Ahhh.. so the atty "guts" came out of the casing, and the wires that connect the "guts" to the battery connector are now broken..?

Unless you're a champ with micro-soldering and have the right equipment.. I'd say this one is toast!