A question about my 306 4ohm atomizer

[VenskeArtStudio]

Hello, I realize that this is the new members forum but I thought I'd throw another question out there to see if anyone could help me. My set-up atm that is giving me this issue is : my (original Hex) Copper set up for 6v with two protected CR2 batteries and a 4ohm 306 atomizer. For some reason it's not working, I get no vapor at all. The same is true when I use my dual coil carts, I don't know if it's shorting the batteries out in the copper but both work fine on my 5v pass through. I use other high resistance (or high volt) 510 atomizers with the Copper and they work great. I can't think of what it is besides me being numb and combining two things that aren't meant to be combined. I would've asked Rick from Atmosusa but I feel like I've sent him a few too many emails lately.

 

[jhonutz]

This device about 4 ohm work`s fine only with a 5V mod or above. It`s an HV atomizer. . If you have step up regulator maybe that circuit is not precise calibrat, and not work well.

 

[dormouse]

He has a 6v PV.

My guess is the throat of your threaded collar is deeper than Ego and they are not making contact. E-Power has a similar problem. Go to Madvapes and get a shorty 510 extender (it's with the adapters). That should help you get electrical contact.

Which dual coils are you using? Some batteries freak at the current draw and their protection circuits say uhuh. I would expect the 2.5 ohm ones to work though if they are getting an electrical connection.

 

[VenskeArtStudio]

I think the carto's are the 3.0ohm dual coils from Madvapes. I'll try getting that adaptor, thanks again for your advice