A strange T3 problem?

[hesta]

Hi all,

Got my kanger t3 delivered today along with a couple of new batteries (cheapies as spares - new to vaping so didn't get any spares at the time). Tried the T3 on my old batt (ego 1100mah passthrough - tornado-C model) no prob really, airy vape but whatever. Eager to prove my new stuff, tried it on the new battery (one of these - Riva 1100mAh Batteries [Colour Matched] £13.99 - Vaping Spares - Batteries & Passthroughs Electronic Cigarettes | Vaping Devices | Accessories | E-Liquid a riva 510 battery).

All was well. Tighter vape on the riva (which I prefer), but otherwise great! Then a strange thing. Put it back on my ego, and no power . Back on 510, no problem. Mini Nova works fine on both.

Any suggestions? Anything is appreciated, thanks guys n girls!

 

[MayLovesMetal]

I used to use an ego pass-through (though probably not the exact same model) that did stuff like that..with mine, it was the center post- it would get tipped a little, the solution was just to take something slim like a model screwdriver, steak-knife tip, etc and gently pry around the edges until it was level again. Mine would almost always work with the mini novas, but get randomly fussy with T3s and other clearos, some of the regular novas..why it would do it with only some, and only some of the time.. I never did figure out.

 

[hesta]

I used to use an ego pass-through (though probably not the exact same model) that did stuff like that..with mine, it was the center post- it would get tipped a little, the solution was just to take something slim like a model screwdriver, steak-knife tip, etc and gently pry around the edges until it was level again. Mine would almost always work with the mini novas, but get randomly fussy with T3s and other clearos, some of the regular novas..why it would do it with only some, and only some of the time.. I never did figure out.

Magical! Gave it a little pry around the edges and suddenly it works again! Thanks so much!