Get a new mod...
Glad everything didnt turn out worse, @wizardofozone. Could it have been the shock of the mod hitting the floor vented the batterys?
You didn't state at what resistance you've been vaping, but your saving grace might be that you're using three batteries in parallel, effectively increasing the amperage X3.
You didn't state at what resistance you've been vaping, but your saving grace might be that you're using three batteries in parallel, effectively increasing the amperage X3.
It uses 3 18650 batteries in parallel.Is the godmod not in series?
It uses 3 18650 batteries in parallel.
Maybe a Provari?And in fairness, I don't know any product that makes sure of safety by slamming it against the floor ,lol !
For all three battery's to pop that fast and all at once there must have been an internal dead short in the wiring. I would not use that box until it is completely taken apart and the spot of the short is found. With that much current there is most certainly a scorch mark somewhere on the positive and negative legs heading to the control board.
I might be seeing things, but those battery contacts seem to be able to touch both the positive "cap" of a battery and the can at the same time if the battery is pressed hard against the "+" contact (bending the center contact metal piece back). A fall could certainly do this and, if it did, could short all three batteries.
I think that a lot would depend on the paper/plastic insulating "donut" being used (at the positive end), and the condition of the wrap, but to me those appear to be incredibly dangerous battery contacts to use.
I would start looking here
View attachment 478310
Please tell me there's an insulator between that connector and the body
Boden, your pic is showing a green circuit board so that's an 180 the 180S has a blue circuit board and they must have seen that and changed the bottom contacts which are about 1/8 inch above the body base. the top contacts rest below 1/8 strip of foam rubber attached to the bottom of the plastic 2 screw cover at the top after you remove the wolf face back of the unit. as a side note, after the fiasco the first thing I did was check the contacts and all were in normal position , plus the new 18650's went in as tight as usual.I would start looking here
View attachment 478310
Please tell me there's an insulator between that connector and the body
Series:
![]()
$74.48 Authentic Simeiyue SMY GOD180 5-180W Variable Wattage APV Box Mod - 3*18650 / silver at FastTech - Worldwide Free Shipping
===edit===
btw in the video, at 4:00 he mentions about the series configuration
"positive... negative...positive...negative"