Adjusting positive pin?

[Commie]

So I have my beloved Grand sporting a less beloved ERA clone. Both my Reomizers, when screwed all the way onto the Grand end up with the airhole pointing towards the door, i.e. 90 degrees short of where they should point. If I loosen them up to where the hole points the correct way (with a thicker o-ring under them), they don't make contact with the positive pin

Both reomizers work beautifully on my Mini. Problem is that Mini doesn't carry enough juice, and is less comfortable to squonk.

So, any chance I can fix it up so that my reomizers would work on my Grand?

Thanks!

Commie

 

[yaypudding]

I think you can just unscrew the rm2 contact a hair.

 

[redeyedancer]

Back off on the center post on the bottom of your atomizer turn it counter clockwise 1/4 to 1/2 a turn . This with a gasket under the atty may get you in the ball park

 

[BillyHill]

Don't know if this will help.
Atomizer and Cartomizer Connection Problems | Vaping Guides to the Electronic Cigarette

 

[Filthy-Beast]

You can also slightly push up the center pin. Might be needed if you've over tightened a rba in the past.

 

[Rev. Stabard]

You can also slightly push up the center pin. Might be needed if you've over tightened a rba in the past.

I'm familiar with raising the center pin in an ego battery, how do you push it up in a Reo?

 

[Filthy-Beast]

Pull the tube and slightly push up on the pin from inside the Reo. If you push up on the pin with the tube installed you could possibly cut the tube and have a leak. Ask me how I know

 

[Rev. Stabard]

Pull the tube and slightly push up on the pin from inside the Reo. If you push up on the pin with the tube installed you could possibly cut the tube and have a leak. Ask me how I know

Thanks for the heads up. Not an issue now, but good to know this stuff. And I'm just smart enough to learn from your experience

 

[Commie]

Thanks, folks! I didn't know that the positive pin in the reomizers was turnable. I was worried about experimenting, it being ceramic and all

 

[ratchet62]

Thanks, folks! I didn't know that the positive pin in the reomizers was turnable. I was worried about experimenting, it being ceramic and all

Needn't worry about the ceramic. The center post and coil posts actually thread into a metal plate that is hiding beneath the ceramic. Turning any of the posts 1/4 to 1/2 turn should not be a problem, as long as you don't use gorilla force.

 

[Commie]

Thank you guys! I unscrewed the positive pin in the reomizer a little bit, and it works great. I have to be careful not the screw it on too tight, but should be fine.

Yay! My favoritest Grand is back from semi-retirement.

Commie

 

[NickCA]

Pull the tube and slightly push up on the pin from inside the Reo. If you push up on the pin with the tube installed you could possibly cut the tube and have a leak. Ask me how I know

How do you know?

 

[Filthy-Beast]

3 or 4 after after doing the adjustment I had juice all over the inside. Figured maybe I'd had a leak from the air hole and it had run down inside the door. Cleaned it all up and had it again the next day. finally put 2 & 2 together and found a small slit in the tube. Luckily I had a spare tube on hand.