advice needed

[vpsi333]

Gorilla juice (100% VG with a high viscosity) seems to freak my batty's out. they flash and quit working when i'm injoying a heavy vape. I can put the batt'y on my menthal tank and it works fine. I've got 5 eGo-T batty's (650 mah) and they all do this. I've switched Carto's and it's still happening. I'm using Smoktech 1.5+/-0.2 ohm DCC's through 6 ml and 3.5ml tanks. My question is would higher voltage, via the eGo booster, help with this or do I have something else going on.

 

[cavibird2005]

Try a single coil. If i remember right when I had a ego (from Madvapes) it did the same thing any time I out a DCC on it

 

[Oban]

Hi there vpsi, I don't think your problem is related to the Jungle Juice. I personally never had much luck using 1.5ohm dcc's or atty's on my eGo batts, they are too low resistance imo. I would try the 1.7 reserectors or Boge lr carto's on them.

 

[vpsi333]

Thanks guys. I'm surprisingly disappointed, must have been trying to justify dropping $60.00 on a booster

 

[Oban]

lol, I too seem to always look for reasons to up-grade. The eGo booster would probably fix your issue as well. Heck, a Silver Bullet and a couple of 18650 batts might even do a better job!

 

[vpsi333]

lol, I too seem to always look for reasons to up-grade. The eGo booster would probably fix your issue as well. Heck, a Silver Bullet and a couple of 18650 batts might even do a better job!

Oban my man, thanks

 

[hubblecraft83]

I agree. I'm glad I stopped playing with the eGo's and got my Silver Bullet. I was killing an eGo a month using low resistance atties. The cheap switch in the eGo just doesn't have the amps you are looking for. Get yourself a SB and some AW IMR 2000mah batts and it will change your life. Cheers