Advice on my vapelyfe hybrid

[Johnnycloud]

I just recently purchased the vapelyfe hybrid and have a few questions. First off I noticed that the posts do not have holes drilled in them. I assume you pinch the wires tight using the screws. Well I am a huge fan of the parallel build, obviously the vapelyfe rda is not very good for this build. I am looking to set this rig up for flavor, any suggestions? Also as a big sub freak I am very big on checking my ohms. It doesn't seem as of checking my ohms is possible with this particular rda as it is built only for this mod and does not have a connector. Any advice would be much appreciated.

 

[classwife]

Moved to APV Discussion from the Modding Forum

Forum: Modding Forum
The home of modders - the builders or modifiers of custom ecigs.

 

[sando7]

i have one also, i just do an exact build on a different atty and check it, then do the same build on the vapelyfe wicked w/cotton......and yep you have to wrap the legs under the screws.

personally i don't care for recessed switches because of my arthritis having to stick my finger inside the switch hurts my knuckles after a short wile of use, so i switched out my Vapelyfe switch with my Orochi switch, works perfect for me.....the Vapelyfe is a great little hybrid set-up that goes un-noticed by most folks, yet i love mine and it's built solid & hits like a train and very reasonably priced....hope you enjoy yours as much as i do mine

 

[Johnnycloud]

Hey thanks for the advice! I really do appreciate it. The vapelyfe is my first authentic so I'm sure it will always have a special place in my heart. Although I'm not to thrilled about having to wrap the wire around the screws I do still love this mod. Thanks again and happy vaping!

 

[sando7]

imo wrapping under the screws makes for a tighter longer lasting coil without having to worry about clipping the legs inside the hole as on a regular RDA.
you'll get it down quickly, not that tricky at all after wrapping a few...enjoy the

 

[Johnnycloud]

Hey thanks, I didn't know that about wrapping the coils on the screw, makes me feel better about it and now I like it a little better, in fact I'm gonna go change the current build. (it's kinda sloppy) thanks again!