AGA T+ came in today

[erawtik]

Woot my new rba came in along with a sheet of ss mesh. Now the only thing that sucks i have 1 piece of wire to get this right cause my 100ft spool of kanthal hasnt shown up yet. How many wraps should i be doing with the piece of wire that came with the kit?

 

[yellowrider]

5-6, but depends on awg and your targer ohm. I usually shoot for 1.8-2.0. Unless mechincal, it will not fire under 1.2 ohms on most mods.
So if you have 32awg, try it at 5 and check ohm.
less the coils, little bit easier to adjust.

 

[erawtik]

Well went with 5 and this is what I got first attempt.

Sent from my PG86100 using Tapatalk 2

 

[erawtik]

Ok now i get a slight metal taste how can i correct this? And do i leave the fill screw out or put it in? After reading all the good and bad things at putting one of these together made me very nervous since i only have 1 little chunk of wire untill my roll gets here so it took me a bit of thinking then i said **** it and did the cig paper trick and worked first time.

 

[medicmckay]

I had to leave the fill screw out with mine. Never did tbe cig paper method. I just drip and burn the heck out of the tip the coils wrap on. Try with a non metal drip tip. Randomly the other day i noticed my juice didnt taste the same with the metal tips.

 

[erawtik]

ok the top coil was turning red so i moved all the coils slightly and twisted the mesh a bit now i dont see any red coils just vapor and no metal taste.

 

[varivapr]

you had a hot spot. fiddling with the coil usually takes care of it. Vape on vaper