Yup. Just take a thin long piece of 300 mesh and squeeze it into the hole. Run it around for about 5 minutes. Don't put a drill to it unless you really sure that's what you want. Even .1 of an mm makes a difference.
Sorry that is for preventing leak. But then if a hole is created isn't it going to allow the juice to flow out of the tank if tilted or upside down? Did I miss something?
Sorry that is for preventing leak. But then if a hole is created isn't it going to allow the juice to flow out of the tank if tilted or upside down? Did I miss something?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.