Recently ordered a twisted messes rda with some coils on the site it says they come out to 0.14-0.17 right now I only have an x cube 2 and they're reading at 0.10 (on my ohm reader and on the mod. while it can still fire it randomly gives an ohms too low warning. Also I'm using Samsung 25r batteries. Is this something I should be worried about?
Alien claptons
- Thread starter BrownManVapes
- Start date
- th_trl_thread_readers 0
- Status
No I think it's the mod doing it's thing
Smok X Cube II 160W Box Mod by Smoktech Features:
You are right on the edge of the Kanthal min for resistance
Smok X Cube II 160W Box Mod by Smoktech Features:
- Dimension: 100*60*24.5 (mm)
- Output wattage: 6W – 160W
- Output voltage: 0.35V – 8V
- Atomizer resistance (temp mode): 0.06ohm – 3.0ohm
- Atomizer resistance (watt mode): 0.1ohm – 3.0ohm
- Temperature control range: 100℃ - 315℃ and 200˚F - 600˚F
You are right on the edge of the Kanthal min for resistance
The build is actually nichrome but same numbers apply it seems. I know it's on the edge it just seems odd that it gives me that message.
Nichrome will read the same.
Check your post screws, see if they are tight and dry burn and pinch your coils. You may be able to raise the resistance a bit and get it to fire consistently. That is a pretty low resistance build.
Check your post screws, see if they are tight and dry burn and pinch your coils. You may be able to raise the resistance a bit and get it to fire consistently. That is a pretty low resistance build.
I didn't even think about that. The coils came preinstalled and wicked so I didn't really want to mess with it. Better to be safe. Really don't want to scrap them.
- Status
