An unusual problem ?

[djsvapour]

i use the big and second biggest air holes most often.

Me too!

I have to say, so far my mini nautilus have been excellent. However, I haven't gone far with one... not even to Sainsbury's...

I have had a few moments at home, but nothing that doesn't go away after a few good puffs. How much power have you got to play with?
Mostly, if it's a bit wet, I blast it at high power for a few goes.

What battery/mod have you got?

 

[Griff.J]

When ever I am leaving my vape in the vehicle when getting out for a while. I sit it upside down in the cup holder. heat will add pressure in the tank and squeeze it out through the wicking holes. In the winter I just keep it in my inside coat pocket to keep it from getting too cold and the juice thickening up too much. I've not tried those tanks though to be honest, they weren't around when I moved on from Protanks to Kayfuns.

 

[Darr00742]

Me too!

I have to say, so far my mini Nautilus have been excellent. However, I haven't gone far with one... not even to Sainsbury's...

I have had a few moments at home, but nothing that doesn't go away after a few good puffs. How much power have you got to play with?
Mostly, if it's a bit wet, I blast it at high power for a few goes.



What battery/mod have you got?

at this time.. until my eVic supreme arrives (with delta tank).. My old faithfull itaste V3, and an Aspire VV+ nothing special atm but I do love my V3.it's been going 2 years without a hitch.

but when the evic arrives.... oh baby!!

I think though.. in the face of adversity.. the nautilus tank can try the patience of a saint.

 

[djsvapour]

at this time.. until my eVic supreme arrives (with delta tank).. My old faithfull itaste V3, and an Aspire VV+ nothing special atm but I do love my V3.

but when the evic arrives.... oh baby!!

I have an iTasteVV v.3. It offers up to 11 watts, but according to some sources, it cannot do the full whack. I noticed it first with dual coil Kanger clearomiser... not much vape compared to the same setting on an EVIC or VAMO.

I think (hope) that with your supreme, you can whack it up to 12,14,16 watts and blast away excess juice.

I've been thinking about an AspireVV instead actually. I have Spinners (v.1 and v.2) but never liked them as much (to use, not the vape quality) as the iTasteVV.

 

[Kevin Geroni]

Happens every time I leave a tank in a hot car. Bdc more often. Basically pressure builds up n the place for juice to go is up the breather tube. Just like a thermometer.

 

[Moaufan]

Switching all of my Protank 2 and 3 bases to aero bases and putting my Nautilus tanks in the drawer has solved all of my leaking and flooding problems. Stock coils have not given me any grief since and I still use the old single coil in both 2 and 3.

 

[Darr00742]

yes I agree.. the V3 drops power easily under 3.8V charge... I don't think it's wattage is accurate.. and I always get best result on voltage option.. i'm really excited about the evic.. especially as it's my 40th birthday gift and marks a milestone in my smoke free life. the aspire VV+ cf is a good battery but it's a sealed case.. I would only get it as a spare but it is a good spare.

 

[HMav]

+1 on turning the tanks upside down, this is the only way I've found to stop a BCC from leaking (other than chain vaping).

 

[Darr00742]

Hi again!

OK.. tried the upside down method which did help.. but it caused liquid to seep un-noticed throughout the day, into the tip.. it's a good method but I then have to detach the tip every time and find a place to put it where it won't pick up dirt.. not convenient for over worked field engineer with not enough hours in the day.

HOWEVER ! seems I found the cure.

I switched back to the BCC version and it's not flooded once.
Well... there is a burn taste above 3.9 volts but I'd rather that than constant flooding.

 

[Warpigs]

I use 5mL PBC Tanks. I have never had 1 leak. I got 10 of them.

 

[Darr00742]

that link won't load for me.. what's a PBC tank ?
Oh I found it.. I'll look into those, thanks

 

[Bunnykiller]

RSST tank.... only leaks when you forget to put the filler hole plug back in and if you use SSmesh