Any experience with this?

Status
Not open for further replies.

ScottChensoda

Senior Member
ECF Veteran
Verified Member
Jun 17, 2013
217
282
Lat:51.53889/Long:0.14743
I concur with your signature milescadre.

es38iQl.gif
 

milescadre

Account closed on request
ECF Veteran
Jan 29, 2014
479
181
Cincinnati, Ohio, USA
Last edited:

Lucky1384

Super Member
ECF Veteran
Verified Member
Feb 9, 2014
400
273
Sheffield, UK
I have a soda, check my Panasonic 18650's and AW 18350's after every charge and they've always been good whether I take them straight off charge when full or they get left for a couple hours. Every single charge gets up to 4.17 - 4.2 volts, never gone over. The switch is normally set to 1A, but is there any advantage to using it at 0.5?

I also regularly feel the temp of the batteries and charger and it barely gets warm. The thermal images on that review make it look super hot!
 

milescadre

Account closed on request
ECF Veteran
Jan 29, 2014
479
181
Cincinnati, Ohio, USA
I have a soda, check my Panasonic 18650's and AW 18350's after every charge and they've always been good whether I take them straight off charge when full or they get left for a couple hours. Every single charge gets up to 4.17 - 4.2 volts, never gone over. The switch is normally set to 1A, but is there any advantage to using it at 0.5?

I also regularly feel the temp of the batteries and charger and it barely gets warm. The thermal images on that review make it look super hot!
I think the thing that kills the soda charger is that it gets hot and makes the batteries get hot. Lithium cells dont like heat.

as far as 1a vs 0.5a, you use 1 amp on bigger batteries (18500, 18650, etc) and 0.5 on smaller batteries (18350, etc). Of course, when in doubt, consult ^^

Not sure if the SOAD auto changes, but I know my Luc doesnt get too warm and auto changes between 1 amp and 0.5 amps depending on the battery put in. so I just leave it on 1 amp
 

Lucky1384

Super Member
ECF Veteran
Verified Member
Feb 9, 2014
400
273
Sheffield, UK
I think the thing that kills the soda charger is that it gets hot and makes the batteries get hot. Lithium cells dont like heat.

as far as 1a vs 0.5a, you use 1 amp on bigger batteries (18500, 18650, etc) and 0.5 on smaller batteries (18350, etc). Of course, when in doubt, consult ^^

Not sure if the SOAD auto changes, but I know my Luc doesnt get too warm and auto changes between 1 amp and 0.5 amps depending on the battery put in. so I just leave it on 1 amp

The current options make sense, thanks :)

I've seen the thermal image of the reviewers charger, but mine somehow is completely different. I even had it charging right next to me earlier so I could regularly touch it. At all times, the charger and batteries were cooler than my fingers, and sniffing at the vents, no warm smell either. In contrast, other chargers for my laptop, camera, iPad etc all get warmer than the soda. I would try rigging my Fluke meter to monitor current, but don't really fancy messing with the batteries in this way.
 

Kaiser Bob

Super Member
ECF Veteran
Verified Member
Nov 3, 2013
584
718
Denver, CO
Status
Not open for further replies.

Users who are viewing this thread