Hey everyone,
Running a spinner 2 with the protank mini 3(new version heads)
Anyway, I have been trying leekeylee's method:
Rebuild Upgraded Kanger Dual Coil to a Single Vertical Coil | E-Cigarette Forum
After a few trys I found that the cotton was blocking the center of the coil which allows air through. I got that worked out so my airflow is good but I just can not seem to get the flooding to stop. Doing about 10 wraps of 28g kanthal and then I use an entire strip of muji (with the width slighty bigger than the coil) and I always seem to get flooding.
I think it improves slightly with a thicker juice but the flooding is still there.
Can't find anyone on the internet using this method wrapping the cotton outside the coils unfortunately.
Any tips or thought?
Running a spinner 2 with the protank mini 3(new version heads)
Anyway, I have been trying leekeylee's method:
Rebuild Upgraded Kanger Dual Coil to a Single Vertical Coil | E-Cigarette Forum
After a few trys I found that the cotton was blocking the center of the coil which allows air through. I got that worked out so my airflow is good but I just can not seem to get the flooding to stop. Doing about 10 wraps of 28g kanthal and then I use an entire strip of muji (with the width slighty bigger than the coil) and I always seem to get flooding.
I think it improves slightly with a thicker juice but the flooding is still there.
Can't find anyone on the internet using this method wrapping the cotton outside the coils unfortunately.
Any tips or thought?
