Anyone using the TORNADO MEGA ATOMIZERS??? THEY ARE HUGE!!!

Status
Not open for further replies.

SuZamme

Ultra Member
Supporting Member
ECF Veteran
Verified Member
When you use the Fluval try this.
Cut it into a triangle shape like an ice cream cone - 3x longer than wide end.
Take the narrow tip end and roll it between your fingers to make a point and keep about 1/4 of it fluffy at the wide end (no curling of this end).
Square cut the swirled point off a tiny bit.
Fill cart with juice. Slip Fluval creation into cart and push fluffy end in until it stops.
Trim excess fluffy off and top with more juice.
I have been using this design for months now and this shape seems to wick the juice the best and no leaking and holds lots of juice and you can vape the entire cart almost dry each time.
When the wicking seems to stop working after a few days, replace with new Fluval and it is good to go again.
 

les017

Senior Member
ECF Veteran
Aug 10, 2010
289
8
Hacienda Heights, CA
Been using mega atty and mega cart for a couple of weeks now and love them. Bigger, better, yet gentler hit than normally atty/cart....at least in my opinion. The capacity is tremendous, running up to about 60 drops in the cart. Personally I have had great success using the stock filler that comes with the mega cart...as long as I observe the following:

(1) Don't go completely full. 60 drops gives me leakage until vaped down a bit. Starting with 40-45 drops seems to work well.
(2) Only 1 primer drop on new cart refill. Two drops seems to flood a bit, while 1 drop just barely floods for the first couple of hits.
(3) Keep eGo on it's side until you have vaped through about 1/2 the cart. Otherwise I seem to get some flooding and leakage. After 1/2 used standing on end seems pretty much OK. In the meantime if you get a dry vape just set the eGo on end for 20 seconds and go from there.

No science to it, but this seems to work for me. I guess different juices, altitudes, barometric pressures, etc, could make a difference as well. :oops:
 
Status
Not open for further replies.

Users who are viewing this thread