Anyway to open a Kanger T2 vent hole w/o messing up threading???

[Yokymo]

So I was wondering why i had to have my Kanger t2 loose on my battery and didn't realize it till today. Noticed that one of the vent holes wasn't properly drilled. This of course is causing a really tight draw and may be one of the reasons I really am not liking the T2 right now.

I really dont wanna take a hammer and nail to it in fear of well damaging it completely.

It works when i have it loose but if i tighten it, it becomes such a tight draw...

Any ideas??

Or should i just count this one as a lose and just get another one???

 

[T41CK]

Would this be the same case on the t3?

Reason I'm asking, I have two of them coming soon and... bump...

 

[denali_41]

i would suggest you drill that hole out a little bit ,think the base is made of brass and if you hammer it ? you only mush up the threads