Are Rba coatings safe? Pvd

[sir_puffs_alot]

Just wondering If anyone has any knowledge on some rba coatings, mainly black pvd which I have on a Magma clone. Will I inhale any harmeful chemicals or byproducts from this while subohming? I dont dry burn this atty for that reason and my best guess is that when filled with juice and air is going over the coils it wouldnt get hot enuff for the pvd to melt. I looked it up and the burn temp for pvd is 454 but the melting point is 212 degrees. Even if its not getting hot enuff can using a anise, lemon lime or citrus juice slowly eat away at the coating to be vaped by me. Its my only black atty. I stay away from coatings usually, but it went so well with my blackmamba chana clone I got one. Any input is welcome,

http://cdn2.bigcommerce.com/server5300/ahbkk2/products/585/images/1423/magmablkbrass__75173.1406274807.1280.1280.jpg?c=2

 

[steved5600]

454 is not all that hot rayon burns at like 420 F. Bit late to be asking since you have it. Guess you could take a dremel wire wheel to the inside to strip off the coating on the inside. I personally stay from anything that is not Stainless steel or glass. Don't even trust brass or copper. Cheap brass can have lead in it and both copper and brass are reactive metals so they might react to some juices. Don't know why they sell them with the coating on the inside.

 

[stevegmu]

You asked for any input. It is made in PRC. I wouldn't use it. There is no telling what that coating is...