Morning Tripsters ... how goes it?
Here Delilah and Reid ... "Kir Fanis Tanks 101".
- Put carto in, punch hole close to the bottom, but not so low you can't see 100% of hole (distortions in tank when punching = leaks)
- fill 90% full, if too full, will cause like a "vapor lock" and you will get dry hits.
If you get dry hits, remove fill screw and place mouth over fill hole, and push/blow juice into carto (just a bit). Replace screw before vaping. Once juice level goes down a teeny, it will feed better, it needs some air in the tank.
- If juice level gets real low, below 20%, carto can over feed causing gurgling/leaking. Think of tank as your car, and don't go below 20%. LOL
If you get gurgling, take tank off mod, take off drip tip, tip tank upside down so air bubble is over punch hole. Place small amount of wadded up TP in tip end of carto and blow from mod end. Air hole must be over punch hole or you just blow out more juice. Keeping tank in position, put mod back on, and vape a little with air bubble over punch hole, helps dry out your carto a bit. Then go back to vaping normal.
** all of this should be done with fill screw IN ... only time you take screw out is to fill tank. Don't fill your carto from the top, or vape with it out. Juice WILL leak.
The Kir Tanks are the best I have used so far, and just a few tricks overcome a lot of problems without having to waste another carto.
