Aspire Naitilus Mini gurgling/spitting?

Status
Not open for further replies.
So I recently purchased an aspire nautilus mini and it keeps gurgling and spitting ejuics into my tongue no matter what I do. I've tried shaking it with a paper towel over the top and pretty much every other trick out there. I won't have money to buy a new tank for a couple weeks and I don't wanna go that long without vaping, but I'm scared of getting ejuice in my mouth. Please help!
 

whiteweazel21

Senior Member
Jan 16, 2015
139
31
I got a regular nautilus, pretty much junk. I think the o-ring in the drip tip got damaged in mine and it would only gurgle. I put a drip tip from my Atlantis on it and it worked but I had already fried the coil by then. I'm not buying any more coils as I've had enough with changing out my Atlantis daily.

If I were you, and you recently purchased it, try returning it saying it's defective. I doubt I can return mine, throwing it out since I will never be using it.
 

bfitz

Senior Member
ECF Veteran
Feb 2, 2013
197
86
ohio
I got the nautilus mini on a whim and it has been on my Istick ever since I got it. I find that when I run the Istick to hot (more than 4 volts) I can get the gurgle and e-juice spit. Not sure what device you are running your's on but maybe turning down the voltage/wattage would help?

I also have only used high vg juices in it. Haven't tried a thinner pg based juice in it, that might make it a little more gurgley (yes, I am pretty sure that isn't a word).
 

Topwater Elvis

Vaping Master
ECF Veteran
Dec 26, 2012
7,116
16,502
Texas
So I recently purchased an aspire nautilus mini and it keeps gurgling and spitting ejuics into my tongue no matter what I do. I've tried shaking it with a paper towel over the top and pretty much every other trick out there. I won't have money to buy a new tank for a couple weeks and I don't wanna go that long without vaping, but I'm scared of getting ejuice in my mouth. Please help!

Gurgling & spitting means the head is flooded or the head isn't tight into the base or you're using too small air hole for your draw strength. It is possible you are under powering it also they seem to work better at higher power levels than other clearos.
Remove head, thoroughly dry air flow chamber in base underneath head, dry bottom of head, dry center tube, install head into base securely (tight), do not over tighten tank to base just tight enough to prevent leaks.

Is it an authentic aspire nautilus confirmed via scratch off security code checked on their web site.

For the occasional flood, turn it upside down so juice level is below wicking holes, press fire button for 2 ~5 seconds.
 
Last edited:
  • Like
Reactions: Rob18014
Status
Not open for further replies.

Users who are viewing this thread