Aspire Quest Mini 50

[Kevsmt5]

Hi guys, pretty new to the game and have just got an aspire quest mini 50. Think j made a few errors when setting up and seemed to have burnt out the three coils that came with it. Just so I know what I doing and buying some new ones could someone kindly confirm the following
That if I want to vape using the canthol coil 1.2 ohm 15 - 20w that I need to set devise to kanthol to ka and keep between 15 and 20 w
Also what VG liquid is best for this type of coil would a 70/30 6mg be OK to use

Thanks

 

[djsvapour]

I would personally not vape a 1.2ohm coil above 15w, regardless. Most of the makers restrict the juice flow to coils 1.2/1.5/1.8 to stop flooding, hence you might get dry hits heading into sub-ohm levels (18 watts and above, give or take).

I use Kangers, Eleafs and Joyetechs around this watt range (12-16) and would recommend dropping down to the 0.5ohm coils for nearer 20w.

Most of the newest coils work OK with 70% VG liquid; again it depends on the design and juice holes in the atomizer head.

 

[Bonskibon]

Start out on low wattage and work your way up until you get a satisfying vape. When I use my Kanger stock coils 1.2 or 1.5 coils 12 watts is good for me.

 

[Kevsmt5]

I would personally not vape a 1.2ohm coil above 15w, regardless. Most of the makers restrict the juice flow to coils 1.2/1.5/1.8 to stop flooding, hence you might get dry hits heading into sub-ohm levels (18 watts and above, give or take).

I use Kangers, Eleafs and Joyetechs around this watt range (12-16) and would recommend dropping down to the 0.5ohm coils for nearer 20w.

Most of the newest coils work OK with 70% VG liquid; again it depends on the design and juice holes in the atomizer head.

Thanks. Would a 50/50 be best I tend to smoke mouth to lung. I think I ended up setting up incorrectly as ended uo smoking and spitting when I tried them all out only to realise I had not turned the mouthpiece from filling to vaping. At least I hope that's what I did and no damage to the unit itself.
I assume the harshness on throat is only ever to do with mg and not the VG level.

 

[Txaggiesaunt]

Thanks. Would a 50/50 be best I tend to smoke mouth to lung. I think I ended up setting up incorrectly as ended uo smoking and spitting when I tried them all out only to realise I had not turned the mouthpiece from filling to vaping. At least I hope that's what I did and no damage to the unit itself.
I assume the harshness on throat is only ever to do with mg and not the VG level.

Are you priming your coils before using them. Put a few drops of juice on them, fill your tank and let it sit for a few minutes. And as stated above, start low on watts and slowly work your way up to your desired sweet spot. Good luck & VAPE ON.

 

[medleypat]

The problem you already figured out when you turn the top to fill shuts off juice flow to the coil. Just install new coil and make sure you turn it to vape and you'll be fine. Been there done that.

 

[Gramdogg]

Yeah, you won't damage the unit. Glad you figured it out. If it's rated 15w-20w start at 10-12w and work up slowly to where you like it to break in a new coil. Like Djsvapour said I vape 0.6 Ohm around 20w so that seems a little high to me but some like it lower then recommended and some even go higher.