atomizer selection for Ali'i VV

[youngll11]

haven't gotten it yet, haven't even ordered it yet (hopefully this friday), but I'm just curious what attys you've been using on your Ali'i VV. I think I want to stay away from LRs if possible just because I plan on vaping at a higher voltage (probably in the 4-5 range), and don't want to be wasting money on attys that only have a one-week warranty (if that).

Also, what batts do you suggest and where did you get them? Looking to keep my batts running as long as possible in that voltage bracket...

Thanks, I can't wait to buy it!!!

Aiden

 

[RedAlert]

For the batts, I used what Ryan reccomended. The AW IMR 16340/ CR123 3.7 volts. As for attys, try and get any you may like around 2.5 ohms. They work good at the lower ranges and great upwards of 5 volts.

 

[mistinthewoods]

I use a Buzz VV. I think one of the ideas behind variable voltage is to experiment with all kinds of attys and cartos of different resistances. I have an 808 connecter on my Buzz and a pile of adapters. I'm dripping into a 3.5Ω HV 901 atty at 5.8V right now and it's amazing. If you've got VV you might as well play with it, I say.

 

[youngll11]

yeah I'll probably get a bunch of different attys, HV, and my normals and LRs. I'm excited, so sick of dripping...

 

[mistinthewoods]

You don't really need LRs with a VV mod. LRs are made to get the most out of 3.7 volts. The amps are high with LRs. You'll just drain your batts faster.

 

[youngll11]

yeah I know, might as well use them if I've got them. I'll probably use them on my egos when I go out, since I'm probably not going to take a massive Ali'i with me to a bar haha

 

[Dogzlife]

Bumping this up and hoping for responses.

I use Ikenvapes 3.5 ohm 510's and 306's on my VV Alii and have had good success with each. Unfortunately, he has been out of stock for some time and I am in need of another source. I did not have much success with the 4.5 ohm (all black) 510's. The five I tried had very poor longevity- one was even DOA.

Therefore, where can I get some decent HV 510 or 306 atties? Does Cisco make anything HV?