Hey all, I have tried to find an answer to this, but nobody seems to have this problem. I am trying to use my GotVapes Hybrid Fuse Multi Use 510 Atomizer on my Zmax, but when I do, the draw is way to tight. It is only tight when on the device because the air holes are getting buried in the threads. It doesn't happen with my cisco spec attys because the air holes are right up against the bottom of the atty, but with these hybrids, the air holes are ever so slightly lower. Any help would be awesome because they seem to vape really well, just to tight. I have also tried it on a 510 to 510 adapter without the center hole, same thing happens.
Atty Air Holes Get Covered. (One More Question)
- Thread starter XtianApi
- Start date
- th_trl_thread_readers 0
- Status
Do you have to tighten them all the way down to get them to fire? Can you back them off a turn to let in more air and still get it to fire?
I have gone further than that. I couldn't get them backed off enough, so I took a leg from a capacitor, bent it in half, and shoved it gently up the center of the atty. That extended it enough to where it would work, but this isn't obviously a permanent solution. This is how I knew that the attys were nice, but within ten minutes the metal bent too much, and I didn't feel like doing this again. I wonder if someone sells a center post with rubber around the base to insulate it from the negative terminal or something that I could drop into my connection to extend the positive upwards. Thanks
The only magnet spacers I know of are battery spacers for inside the mod, but I'll check it out. Thanks for the reply
- Status
Similar threads
