Atty vs Carto TH

[damthisisfun]

I am so confused. KGO 1100 Mah came with a 1.5ohm atty. I vape JC Red Oak Domestic and Tennessee - both 100%VG. When I vape using my 1.7 SmTech Carto - the TH is wow. Yet when I drip in the atty - hardly any TH. Based on my limited knowledge and posts I have read, the lower the ohms, the more the heat and more the TH - if that is correct - why is this happening to me........please help. What am I doing wrong?

 

[Unforeseen]

What's the brand of your atomizer? Did you prime it before vaping? Did you blow out the primer? Basically need more details in order to assess the situation.

At any rate, a 1.5 ohm atomizer might pull more amps than what the switch may allow. So, I suggest using that combination with caution.

 

[damthisisfun]

Hmmm - I was wrong - went to check back on the site I got it - it says 2.0 ohm LR - no brand. Bought the kit from Hoosiers. I did blow out the primer, have cleaned it a couple of time by rinsing with vodka and water. It seems to work fine - just that TH is not there. Maybe I answered my own question - I need to get a 1.7 or 1.5 ohm dirpping atty?