Authentic 4nine FOC

[nuvole]

Giving away a 4nine v1 mod(used)
This mod run with 18350 or 18650 with extention.
Giving away with focalecig switch and magnet.

This mod have been giving me loads of arcing problem.
Taker will have to sand/grind/clean the tube very often.

First member from SG post a reply that show you have the capability or photo of your sanding/dremel tools will get the toy with condition as follow:-

- Pass on your sleeping/retired mod or rba to another SG.

- First come first serve basis, and only if you trust me enough to give me your postage address.

- Not for dealer pls

Note that I'll be dropping the package in singpost mail box. I would not be keen to see ppl jumping on me due to slow mailing system.

 

[Bakpau]

Woah bro.You really are a savior for those newbie here.But i suggest newbie not to take since it would be a pita to drilll/sand and at the same time have to learn about the safety of the mech mod since it will require some "mod"

 

[Tankteam]

Wa bro forgo this 4nine what mods u going for? Cos me oso looking for new mods hahaha

 

[nuvole]

Wa bro forgo this 4nine what mods u going for? Cos me oso looking for new mods hahaha

I've switch Gus mod. Its longer than this 4nine, but trouble free so far.

 

[chia]

Nice .. I Kanna short b4.. But how to know if mod is arching?

 

[nuvole]

Nice .. I Kanna short b4.. But how to know if mod is arching?

If the mod is arching, you'll find some rough surface between the contact point.
For 4nine, the inner part of the tube where the switch is contacting the tube will show rough surface.

 

[Syn007]

This is against ECF rules. No selling/buying/trading anywhere but classified. Giving out stuff like this is considered trading by ECF's term. Pls don't do this again here.