Available Now - SMOKtech Kick Clone Power Boost Regulator - 5W - 12W

[ROM 1]

Short protection, low voltage protection and reverse battery shut off...

Thanks "rdsok" for the response. I'm definitely going to get this now.

 

[WallyO]

One more question I have not seen on this. At least in this thead. Most regulated mods won't fire below 1.2 ohm coils. Does this have the same limits? Or will it fire an rba below 1 ohm?? Hopefully someone who has one of these can provide this answer.

 

[rdsok]

One more question I have not seen on this. At least in this thead. Most regulated mods won't fire below 1.2 ohm coils. Does this have the same limits? Or will it fire an RBA below 1 ohm?? Hopefully someone who has one of these can provide this answer.

I'm stealing the following from elsewhere...

The SMOKTECH The kick has many built in safety features.

Low voltage cut off.
When battery volts is 3.2v, the low voltage protection disables the mod from working to protect the battery and user.
Low Resistance cut off.
When output resistance is lower than 1.0ohm, the kick will enter into low resistance protection.
reverse battery shut off.
over heat protection.


Specifications:

the kick can be used with 1.5ohm~6.0ohm atomizers, with the 5W~12W variable watts, sequence with +/-1W.

Max current is 5A

RMS output(so you set what you get).

I've also read that it works best with a 1.3Ω or more coil... the quoted info states a 1.5Ω... so there is some variation in what is being said about it. Personally, I typically don't make coils less than 1.5Ω and usually use 1.8Ω or there abouts.

 

[dannoman]

Thanks rdsok for answering some questions for us here!