Ballpark resistance I might want on an Ebaron Dripper Spiral.

[TheBikeGuy]

Howdy, I just got a deal on a Reo Grand. One of the atomizers that was thrown in was an Ebaron Spiral. It's probably going to be a real pain, but I would like to play around with it. My biggest problem with it is, playing around with it could get expensive fast. I would like to just buy a box of ready made coils in a cup for it at first. They aren't cheap.

I don't really want clouds at all. I like being able to vape anywhere. I mix 100% PG and I've been using a smok PBC v1 at 7 watts or less because the flavor gets kinda burnt if I go too low. It's basically a large volume Protank. I usually rebuild the heads at about 2.2-2.4 ohms. From what I'm reading I'll probably want to go lower with a dripper, but I have no idea how low, since I've never had a dripper. I would like to buy one set and at least be in the ball park. I'm thinking I would want to go a little lower anyway since the legs are non resistance and don't count. I'm thinking about 1.8, but don't really know.

Thank ya,
Rory

 

[Wolfenstark]

Guess you can put in the Ω you want well depending on your batteries.

Use an ohms law calculator to see how much amps you will be pulling from your batteries and check they're capable.

My dripper so far i've just done to 1.4Ω single coil though now that i have a new mod and batteries I'll have a go at lower Ω
usual tank i have around 1.5-1.8Ω

 

[TheBikeGuy]

As much as I hate to,maybe I'll just hold off on buying anything for the Ebaron until after it gets here. I'll have two other drippers to play with that will only cost me some 30 guage wire and cotton balls to dial in. Once they are like I like, I should have a pretty good idea of what NR/R/NR wire to buy for the Ebaron.