Best atty for Infinity?

[frequentj]

I ordered an Infinity from notcigs today and I'm so excited! I've been looking around trying to find the best atomizer for it (510) since this will be not only my first variable voltage mod, but also my first high volt one. I know you aren't supposed to use an atomizer rated at less that 2.8ohm, but the HV ones I've seen are rated way higher than that. What's a good all around one that will perform at different voltages? Where's the best place to buy one? Thanks!

 

[methic2345]

i use plain boge cartos on mine, but you can also use regular resistance 510's and 306's, they sell them at a lot of places, ikenvape, cloudsofvapor, goodprophets, madvapes, avidvapers...just go through the registeered suppliers on the forum

 

[frequentj]

i use plain boge cartos on mine, but you can also use regular resistance 510's and 306's, they sell them at a lot of places, ikenvape, cloudsofvapor, goodprophets, madvapes, avidvapers...just go through the registeered suppliers on the forum

So you haven't had any trouble with the regular resistance attys? That's what I was planning on using, but I wasn't sure if the ohm level was high enough. I'm getting some more cartos as well, and using the regular resistance would sure give me a lot more options.

 

[WomanOfHeart]

I wouldn't use a standard resistance atty while vaping at higher than 5V. I have used standard resistance at 5V and below without a problem. In fact, I have a standard atty on my Chameleon PT right now and it's giving me tons of flavor and vapor. However, once you start getting up to 5.6V you start pushing the watts. It's going to get too hot and at the very least make your juice taste burnt. At the worst, it's going to pop the atty. I would say that if you're going to vape at 5.6 and above that you get a HV atty of at least 3.5 ohms.

I think IkenVape is sold out of the HV 510's, but PureSmoker might have some!