Best easy clean for Fluxomizer?

[robl45]

is there a quick easy way to clean these things? I got some, out of 3, one still working great, the other two, are working, but no where near as well as one of them. 2 are usuable on 3.7v battery but at 3.2 volt are useless. all used the same amount, all used with same liquid. I tred cleaning one by rinsing in hot water and then dry burn, it seems to be better, is that the best way?

I think part of the problem is that liquid is always running down the center when filling them because you never know when they are filled, but I can't use the clear ones because they just fall apart.

 

[harmonic]

Sounds like normal buildup to me. Rinse and dry burn you got it! juice running down the middle wont hurt anything but whatever it drips on. Blow out the ce2 and your good to go

 

[robl45]

Sounds like normal buildup to me. Rinse and dry burn you got it! juice running down the middle wont hurt anything but whatever it drips on. Blow out the ce2 and your good to go

actually I did this, but still hasn't recovered. and the cartomizer was only a couple days old. I rinsed under hot water and dry burned, maybe I needed to do it for longer, I didn't want to pop the cartomizer.

 

[harmonic]

idk ymmv but i have only had one pop in my several months using them and it wan an old one to boot anyhow. i mostly are using them on my epower and several unregulated box mods. but i only clean mine once in a while because i am concerned about the wicks falling off but when i do i really light them up 5+ second burns and i do it a bunch of times until all the crud looks burned off. sometimes they just dont want to get good again though. you also have to watch that the inside of the cup seal does not touch the coil or wires. it has a little lip that goes inside the cup and once in a while it will touch the wire and get burned and i think that it gets on the wire then it stays funny tasting...
i hooe this helps and you get better mileage out of the other ones lol