Best Hight Voltage Atomizers for vapor production, last, and taste
- Thread starter AaronY
- Start date
- th_trl_thread_readers 0
- Status
Another vote for Ikenvape!!! Mums the word tho I HATE it when they sell out....
801 atty hasn't yet leaked on me.
That's not to say it isn't possible....
Goosenecks are nice for sure, but not a 'must have' for the Darwin. The swing arm itself kind of acts like a gooseneck. If you've got the money, grab one
It is sealed up pretty good. The thread and air intake is quite different on these.
I have an Empire Mods drip shield that I use with 901 and 510 stuff.
You can also use rubber gaskets and a 510:510 extension or adapter to make a simple drip well.
That's not to say it isn't possible....
Goosenecks are nice for sure, but not a 'must have' for the Darwin. The swing arm itself kind of acts like a gooseneck. If you've got the money, grab one
It is sealed up pretty good. The thread and air intake is quite different on these.
I have an Empire Mods drip shield that I use with 901 and 510 stuff.
You can also use rubber gaskets and a 510:510 extension or adapter to make a simple drip well.
Last edited:
I'm using 4.2 Ohm on 5V PT and my impression is it's a little bit too high for 5V. I've never saw a coil gets red no matter how long I push the switch. Besides that the atty resistance going up and it's 4.7 Ohm now (coil gets thinner with burning).
I think 3.5-3.7 is an optimal resistance for 5V. I wish could afford Ikevape attys.
I think 3.5-3.7 is an optimal resistance for 5V. I wish could afford Ikevape attys.
- Status
Similar threads
