Best RDA for MVP2?

[RHG10]

Hey everyone, I'm looking for some rda clones to put on my itaste mvp 2. I've done a little research and I like the omega from hcigar. But I'm also a rookie builder and only know so much about rebuildables. Any suggestions on what I should get? Probably something around 20 dollars. Thanks!

 

[huhhman]

My Stillare clone and trident v2 clone are my go to for rda's currently. They work great on my mvp2 around 1.4ohm, but really shine on my mech mod.

 

[pharzus090]

Just get an I-go w. You can find them for 10 to 20 bucks. Play around with it, then figure out what you want. Rdas are cheap enough that clones are not really needed. I usually go for clones of mech and vv/vw mods as they are just outputting the power and are much cheaper. Look up hana modz clone at elev8vape.com I pre orderes two of them for 70 buks a piece.

 

[Fisheeboy]

I recently got an IGO W to use on my MVP2 and it works well enough. But no doubt I need to drill out the air holes a bit because as is there is not enough airflow for the coils I build on it. I also have a little SMOKtech rda that I added an air hole to and it works like a champ. I have no doubt that once I get better airflow with the IGO W it will work great on my MVP2

 

[pharzus090]

I would actually say just get an I go m. They are 40 to 50 bucks. But they have a deep well, dual + posts to support lower guage wire, and can be rotated for adjustable air flow. All of that is only really necessary if you want to sub ohm though.

 

[Jscheiben]

I just picked up a patriot clone today and am loving it on my MVP 2

 

[RHG10]

Thanks for the input everyone!

 

[DasBluCig]

Just another "chime-in" vote for the IGO-W or -L......Both work great on my MVP2, using single 1.2 ohm micro coils and cotton wick....
On the IGO-W I just blocked off the extra air hole when using the single coil......some like to drill out the holes, but I'm partial to a "tighter" draw and find the stock holes are fine.....YMMV.....
Happy (vaping) Trails!

 

[joecil]

I also suggest an IGO-W with a Halo top cap (makes it 22mm) or IGO-M as both work very well with the MVP 2 at 1.2 to 1.8 ohm builds.