BLISS rba pics and setup

[cornolio]

So I received it today from elitevaporworks after ordering it Monday.very nice construction,smooth threads and quality finish.
still trying to find a good setup.



Tried hollow wick 400 ss with 5/4 wrap single coil 32g kanthal.massive throat hit 12 mg 70/30 pg/vg juice probably because of the two air holes on opposite side.tried 50/50 pg 0 nic and still getting tons of throat hit.
after a lot of tinkering I plugged up one air hole,decent vapor,wicking problem when chain vaping and super tight draw.



Been working on it for a couple of hours so ill back off a bit.if any of the experts can chime in and help,I'd appreciate it greatly.
sorry if the thread title is misleading but I can't find a lot of info on this atty
i have pics and setup anyway

 

[FunkyVapes]

I actually started a thread here about the BLISS and its wicking problems. I still have issues with it. It will not feed with a proper wick, it has to be hollow, and significantly less in diameter than the wick hole which means it doesn't "hold" much juice - so what I consider to be chain-vaping is impossible.

However, I always forget it was specifically designed for using dual coils so the idea of higher resistance coupled with smaller wicks may help the performance, I haven't experimented enough yet, but I will surely post my findings

 

[cornolio]

I actually used your videos to help me set this up.throat hit calmed down alot now,breaking in probably helped,im getting better vapor and wicking right now but flavor is lacking.pls let me know if you come up with more info.ill start tinkering again in a while and post here if i find out more.

 

[Whoopin]

Try squeeze in a 50-60mm wick, use twisted coils, and it should fire fine with better flavor

 

[cornolio]

Whoopin; I will try that next


Running double wick right now.still lacking in flavor.6/5 wrap on each coil coming in at 1 ohm.waiting for it to
break in more