Bobas in a Boge (or any other suggestions!)

[wildarmtins]

I've tried vaping Bobas in a carto tank with a 2ml hole. Works brilliantly for 5 mins then the tank floods / heating coil stops firing properly (I can only assume it's because it's gunked up with juice). I've wasted 3 cartos on this now so I'm thinking about just watering down the juice by 10 / 20% and putting it straight in a carto, no tank.
Any suggestions?

Sent from my LG-P920 using Tapatalk 2

 

[Monoxxide]

I punch 4-5 (depends on size wat i see after punching) holes in my boges with hammer and a nail, for my bobbas tank, never have any flooding at all. 4-5 days then they are gunked up and ready for a boiling in water session. For my 70/30 liquids i punch 2 holes...those cartos go easely over a week if not 2 full weeks.

With 1 hole in a carto and bobbas i rather think your burning your cartos up over gunking them up.

 

[wildarmtins]

Cheers for the input!

I used a nail to punch the hole, the centre tube is fine. It was weird though, when vaping bubbles were coming from the bottom of the carto, below the hole. I couldn't see where as it was above the rubber o-ring but below the punched hole :-S

Sent from my LG-P920 using Tapatalk 2