Bobas in a cardo tank??

[Dnorager]

Hey everyone, I'm looking for some suggestions on how to get bobas to work properly on a tank. I use a j-tank, and it works flawlessly, but bobas seems to be a little too thick for it. The cardo just doesn't seem to stay saturated enough. I heard that putting three small holes in the cardo is the best way to go. I can punch them myself, I just want to know the best way before I ruin any cardos. Any advice would be terrific, thanks.

 

[9teej]

I have been using bobas in a tank with a 1.7ohm smoketech for three weeks without any big issues. I punched two decent sized holes in the carto with a 1/4" saddle valve and it has wicked flawlessly.

 

[DoubleHelix]

Yes, be sure to have more than just 1 hole or 1 slit. I like to fill up the carto pretty well with either a syringe, condom method and taryn spin to get things moving a long. But It still does not beat dripping on a nice attie IMHO

 

[mwa102464]

Cartos are cheap, dont worry about experimenting it's part of the deal when vaping, like the others have stated try two nice size holes, its what I do for boba's in a carto and it seems to work for me, though dripping it in a nice Atty set up with a drip shield or DCA rules over a carto, you also may want to try two Atty's for your Boba's. the Ikenvape i06 and the HH-357 the flavor you will get will be much nicer then running it in a tank with carto, just saying and both of these Attys you will net a lot of vapes with only 4-5 drops, I get 15+ vapes with my i06 using my Bobas and I have found I dont waste juice this way and get more flavor and just a nicer vape, though I do use tanks on occasion and enjoy them too.

 

[Dnorager]

Thanks everyone, I have heard alot of good things about using attys, but they seem complicated, I've wanted to get a couple for a while now, but I know absolutely nothing about them. I've been a cardo vaper for over a year now. I've heard that most attys don't work well at a higher voltage. I would absolutely love getting more flavor though.

 

[DoubleHelix]

Atties work just fine at higher voltages. You just cannot really stick a 1.7 or 1.5ohm on too high of voltage. With my buzz pro I usually get SR > 2/5 ohms and just adjust from there. Atties do take some practice, and I prefer 306s and bridgless 510s but practice makes perfect and I would have it no other way. I have a liquinator sittin in my storage box that may never get used again to be honest.

 

[wwturner]

I've used Boba's in just about every fancy carto known to man, and also inside my homebrew tanks. It's always worked well, but the worst part is wasting my precious Boba's that's left in the carto when it starts tasting funky and needs replaced.

NOW that I've discovered the wonders of Juiceboxes, there's virtually NO waste, and once you get the hang of it, the taste is literally "Out of this World"!

 

[mikegun]

you can cut BOBAS safely, by adding 2 drops of water per 10 mil, it will thin more then you think and u wont lose flavor, i do this with punched cardos in my j tanks....

 

[madsen6466]

Just got my first tank in the mail! Slapped a xl kanger in my new liquinator - properly punched with a 1/4" valve punch and my vaping is immaculate!