So I was tinkering around and I've been vaping on this single coil I built on my igo l, really love it produces lots of vapor and has great flavor it's a triple twisted 30g nano coil and I was going to put duals on my helios well I did and they both seem to heat up fine but after a few fires I could feel my bottom button getting warm so I immediately stopped and took it off. They were coming in at around .3 and I was using it on my kamry k100 with Sony 30amp battery I couldn't see any visible shorts any ideas?
Bottom button got warm
- Thread starter Cory Cooper
- Start date
- th_trl_thread_readers 0
- Status
That often happens when you have alot of crap building up on the bottom connection. Give your mod a good cleaning and see if its helps
i'm running dual twisted 28g at 0.31 ohms and my button doesn't get hot...has to do something with your mod
A 30 amp battery if it actually is rated at 30 amps shouldnt break a sweat
Why do you say the Sony batteries are crap? Everything I have heard/read says these Sony batteries are some of the best.
Not certain if you're just trolling.
Right on I haven't gave it a good cleaning before, every now and then I wipe off my top contact, and .3 is the lowest I've gone I wasn't sure if my kamry could handle it being a cheaper mod I should have my new mod coming in this week, but it's a clone from ft so I hope it's not worse.
oh probly a important thing I left out cause I wasn't sure if I'd get reply is that my pos helios clone one if the ss screws on the positive post got striped out (the hole) and I found a tad bit bigger screw to replace . It wasn't ss, had some kind of black paint coating but it tightens down fine and it didn't give me any crazy ohm readings. So ill try the cleaning first.
- Status
Similar threads
