I have a mod that will do 60 watts, but I usually vape at half that or less. Just for fun, I wanna build a build that can handle all that power. What do you suggest? I've got Kanthal and SS316L both in 26 & 28g sizes. I can't make a Clapton but I could probably twist some wire if that's not low enough. I've got a Derringer, Velocity Mini, or Twisted Messes Squared to put it in (or a Subtank Mini or a Magma but I don't think they're up to it lol.) What do you think, can I even roll 60 watts with that, or am I asking too much?
Build for 60 watts?
- Thread starter bwh79
- Start date
- th_trl_thread_readers 0
- Status
I think air flow with those two will be the stop point for watts, you might be able to see something close to 60w with the STM but just barely if you are lucky.
Maybe you should just look for a good vape with what those tanks will do?
I am a STM guy and run 40 watts at .55 clapton and make it work just fine. to each his own.........
Maybe you should just look for a good vape with what those tanks will do?
I am a STM guy and run 40 watts at .55 clapton and make it work just fine. to each his own.........
24g, 317L, 11/10, 3mmID, .23ohms spaced. Wicked with Rayon pulled through tightly. I can slam this at 80 watts no problem. At 60 watts it's a dream. Put this in a Goon528.
Last edited:
Maybe you missed the part where I said "just for fun, I'd like to...". I already have setups that give me a good vape at the wattages I usually vape at. I just want something that'll do 60 watts once in a while, just because I can push 60 watts with my device.
Yea cool. Hard to put a high watt build on those attys.
Okay thanks, that's what I was wondering. Even the V.Mini and TM-squared? They both seem to have plenty of airflow. Are they just not big enough overall, do I need a 24mm atty or something?
Yep. You need many wraps and the smaller decks won't cut it. There are plenty of 22s that will handle more wraps though. Stepping up to a 24 surely solves it as well.
- Status
Similar threads
