Build for minimal nicotine extraction

[brunotorres]

Hi all,
I have loads of 18mg juices here, some very expensive that I don't want to waste.
When I started using the kayfun, it stroke me as a hell of a nicotine extractor. I can't vape the same nicotine concentration as I did on the nautilus or the evod.
So, what's the way to extract minimum nicotine with still getting full flavor, if there's actually a way?
Should I use higher gauge wire? Silica instead of cotton? Higher resistance and lower voltage?
I use an eleaf istick with a kayfun lite pro v2 EHPro clone.
Maybe that's a ridiculous question, but one worth asking if I can not waste my expensive halo juices.

 

[93gc40]

Buy some unflavored or matching flavors in ZERO nic juices.. Only way your going to reduce the nic level, without ruining the juice is dilution.

 

[93gc40]

You could just vape the 18mg at a lower power setting......

 

[Ou2mame]

I would just buy the same in 0 and mix them. Going from a clearomizer to an rta, I reduced my nic in my next order.

 

[SkvLTD]

Or just wrap a 1.8ohm coil and use a lower power setting on your battery.

 

[brunotorres]

Thanks, I'll try to dillute the juices.
I already bought a batch of 6mg juices, I think that's gonna be my nic level going forward.

 

[ckquatt]

If you have some straight VG you can dilute it say 50/50. I've done it a few times and had minimal flavor loss.

 

[Technonut]

Moved from Rebuildable Atomizer Systems to Coil Builds...