Build help! First RDA ever: Mutation X | 28G Kanthal A1

[jaxgator]

I also build my coils center and close to the edge of the deck. My build on the V2 typically meters between .16 and .2 Basically I can blow rain makers.

Yeah, I've finally dropped down to .18Ω myself and it's my sweet spot.

 

[whosrandy]

Can't wait for my Ohm reader to show up. I'm going by guesstimate / IPv2 reading which isn't very accurate . I want to know what I'm really running.

 

[KeepItSimpleStupid]

U only live once.

Aint that the truth tho, Get some VTC5's and drop them ohms low low low and see how you lik lik lik it, i be be bet you will, lol

 

[nyiddle]

Get some VTC5's

VTC5's don't exist anymore as far as I know.

Be wary, most batteries (despite advertising higher) only have a 20A limit.

 

[systemcrash]

I don't want to ninja the thread, but I think it's better to create a new one.

I got a authentic MX v1. I used the same build that I used to do on my magmas, (dual coil, single 28g kanthal, 5/6 wraps for 0.55 ohm). All I can say is... I prefer the magma by far. Not only the flavor from the magma is way better but it produce a lot more vapor and it's considerably thickier. I changed the wick few times and still the same result.

My coils are placed a bit lower (maybe 1 millimeter lower) than the central post hole and aren't centered. They're placed between the negatives poles and positive pole.

To be honest, I didn't get the MX for the flavor, but to make some cloud. Needless to say that I prefer to use magma for it so far.

Any recommendation would be appreciated. I don'T think I will get lower AWG kanthal anytime soon...

Thanks

 

[whosrandy]

I don't want to ninja the thread, but I think it's better to create a new one.

I got a authentic MX v1. I used the same build that I used to do on my magmas, (dual coil, single 28g kanthal, 5/6 wraps for 0.55 ohm). All I can say is... I prefer the magma by far. Not only the flavor from the magma is way better but it produce a lot more vapor and it's considerably thickier. I changed the wick few times and still the same result.

My coils are placed a bit lower (maybe 1 millimeter lower) than the central post hole and aren't centered. They're placed between the negatives poles and positive pole.

To be honest, I didn't get the MX for the flavor, but to make some cloud. Needless to say that I prefer to use magma for it so far.

Any recommendation would be appreciated. I don'T think I will get lower AWG kanthal anytime soon...

Thanks

The Mutation v1 is a beast. It's designed for thicker wire and serious subohms. Try out a .2 build with 24g, 3mm and minimal cotton so the air can disperse freely. Beastly clouds no doubt. I see a LOT of builds with less than .1 ohms with the MX.

I began building the MXv1 with 28g and was not a fan. Check out the Fogwind Vapor Group Buys page on Facebook and see all the crazy coils being built for the monster known as the Mutation X.

Once received, I plan on building my Magma for ADV, conservative warm vape with good flavor, and then build the MX for pure clouds. I know there's no competition when it comes to vapor production, though I hear Magma is no slouch.

 

[KeepItSimpleStupid]

They do exist, look around, you can still find em

 

[jaxgator]

I know there's no competition when it comes to vapor production

Actually there is. The Doge comes to mind.