Are you saying if I vaped 100w from a 1.5 ohm parallel dual build.. and a 100w from a .2ohm parallel dual build there would be no difference in the vape?
Building my first dual macro coil.. Having trouble centering the coil.
- Thread starter 3ebmike
- Start date
- th_trl_thread_readers 0
- Status
Are you saying if I vaped 100w from a 1.5 ohm parallel dual build.. and a 100w from a .2ohm parallel dual build there would be no difference in the vape?
I figure I wouldn't be able to reach anywhere near that wattage with a build like a 1.5 ohm build.. so that's why I was building the way I was. I'm a cloud chaser and just prefer sub-ohm builds.
If you try to vape at 100w on a 1.5 ohm build you'll melt your wires
And as far as thicker wire goes, just note that as the wire gets thicker, it starts to have a substantially longer heat up and cool down time, thermal mass and what not
If that build covered the same area of wick and you had a mod that could push 12.25V then yes it would vape the same.
Edit: not quite the same. The thinner wire would heat up and cool down faster than the thick wire.
Last edited:
That's why I was comparing a 0.7 to a 0.2 ohm build. You only need 8.23V to hit 100W with a 0.7 build.
1.5ohm would be a bit high with the mods avaliable although I'm sure one will be along shortly that could do it.
That's why I was comparing a 0.7 to a 0.2 ohm build. You only need 8.23V to hit 100W with a 0.7 build.
1.5ohm would be a bit high with the mods avaliable although I'm sure one will be along shortly that could do it.
The way vaping is advancing so rapidly I'd have to agree.. it's like every other day the next big thing is out.
- Status
Similar threads
