Bulli A2 Atomiser and P10

[quendelyn]

You know, I just received my A2 on friday. It looks great on my P10. Finally figured out how to upload a pic. Gave it a review on another thread. The combination is stellar. My quest is over. Th, flavor and tons of vapor all there. My P10 just delivers all the power it needs. Even at low resistance! This is the Best!

 

[Portugal Barry]

Im vaping 306lr'r for a lot of time now and im wondering if i buy a bulli a2 am i going to miss something like Th vapor etc. ?

The simple answer is NO to all! The bulli gives just as good throat hit and just as much vapour. Depending on what resistance you wind the coil at you can get the same result. I use Cisco 306's @ 1.5 ohms and find the Bulli at 2 ohms hits just as hard most of the time and you can go down from there if you are brave enough to try!
Have fun.

 

[fermthe]

How is the nichrome quality you get for this atty, does it lasts longer ?

 

[Maz]

I use Cisco 306's @ 1.5 ohms and find the Bulli at 2 ohms hits just as hard most of the time

I've been saying this for almost a year about CE2s and most think I'm off my head. It's the wick passing directly through the coil that does it I think, rather than the gravity fed set-up of traditional atties. This configuration allows more juice to be vaporised at higher coil resistances and lower temperatures.

My 2.6ohm clearos easily outperform the 1.7ohm 901 atties I used to use.

 

[forcedfuel50]

You know, I just received my A2 on friday. It looks great on my P10. Finally figured out how to upload a pic. Gave it a review on another thread. The combination is stellar. My quest is over. Th, flavor and tons of vapor all there. My P10 just delivers all the power it needs. Even at low resistance! This is the Best!

Looks great quendelyn, thanks for the Pics!

 

[Cry79]

I am using the A2-T with P10 and P16
really fantastic
especially the P16 with the A2T is also beautiful

 

[Vaporologist]

It does look sexy on your P16.

 

[quendelyn]

How is the nichrome quality you get for this atty, does it lasts longer ?

The wire supplied with the A2 is kanthal. I like it much better than the nichrome. Though would use nichrome in a pinch. Just get lower ohms on the kanthal with the same amount of winding. Love it on my P10, and my batterries are lasting a lot longer usimg the A2. I also have the A2-T, but prefer the original.

 

[Barefoot Joe]

I just bit the bullet and ordered an A2-T. Can someone direct me to:

1) US (or shipped to US) sources for extra kanthal?
2) any directions about wire diameter/ number of windings for different resistances (I am assuming you check with a voltmeter)?
3) any sources for extra wicking and type/diameter/ material?

Thanks!