Bulli A2-T Atomizer Question

[DEATHTOCIGS]

I've heard the Bulli A2-T atomizers can be modded to lower the resistance, anyone know how this is done? Do you need different wire for the coils or do you just make more coils with the same wire? I have one on order and I'd like to get the most out of it once it arrives.

 

[lexi60]

Less wire is lower resistance.
Or a higher gauge (thinner) wire.
Eg: 4 coils would be 2.0ohm. 5 2.5 ohm, 6 coils 3.0 and so on.

Sent from my HTC Glacier using Tapatalk

 

[DEATHTOCIGS]

Thanks for the reply lexi60.

So does that mean 4 coils would run hotter than 5, i.e. more vapor?

 

[jmarkus]

less coils runs at lower resistance, hotter vape at lower volts, which i guess could mean more vapor.

 

[saw4]

i use 6 coils 2x0.15 twisted, 1.7omh

 

[BuddyD]

If you want to do lower resistance atomizer coils I would suggest going to Kanthal wire. 32awg is a good size to 36awg, I have been using 32awg and three to four wraps to get 1.5 to 2.0 ohms. Once the coil breaks in its smooth and produces very well. Nichrome works but I prefer the Kanthal for the lower resistance coils personally.

 

[SCORPIUS]

I use both the Kanthal 0,16 & 0,20. 6 turns of the 0,20 with 4gf gives me 1.7ohms & 5 turns on the 0,16 gives 2.8Ohms. But still is a learning curve and it keeps varing depending on the length of the wire. I normally cut 3 to 3.5 inches.

Amazing vapour , flavour and TH.

 

[DEATHTOCIGS]

Where do you guys buy the kanthal wire? A vaping site? In the US?

 

[Dudeman]

Where do you guys buy the kanthal wire? A vaping site? In the US?

Resistance heating wire, Kanthal A-1 32 awg 75ft | eBay

This is what I've been using. There are a lot of differnt guage Kanthal available.

 

[quendelyn]

I use 3 windings to get low resistance of 1.7. Either kanthal or nichrome. I prefer nichrome as I don't like that aluminum is used to make the kanthal more malleable. Am leary about inhaling aluminum fumes. I get my nichrome from madvapes. Also, nhaler has a bundle of wicks and some wires for their ato-miser. I make a thin wick by braiding 3 tiny strands of this wick material. Not bad, though I really prefer Bullis wick.

 

[DEATHTOCIGS]

I never heard that before, Is inhaling nichrome fumes any better?