RDA Bulli problems

[lo4th]

I have just recently purchased a bulli off the forums and for the life of me can not get it to fire. At 1st I tried the mesh wick only and noticed in the video the guy had darker mesh, so i figured something had to be done to it 1st before it would work. So i tried the normal method (just the wick no mesh) and both my provari's read op. I tried it on my silver bullet and 2 different ego batteries and it would not fire. So then i just tried wrapping the wire around both posts with out any wick and making sure they were not touching. Still nothing no fire and OP on the provari. I am not sure what else to do any help would be awesome.

Provari v1
Provari v2
Silverbullet
2x Ego c 650mah
32 kanthol
mesh squares
wicking material
Bulli

 

[Flyer]

I've never rebuilt one, but it sounds like a contact problem. Do you have a volt/ohm meter? If so, you could confirm if the coil is connected to the right elements of the 510 connector. That's where I would start unless I could visually identify a problem.

 

[classwife]

Moved to Rebuildable Atomizer Systems from New Members

 

[lo4th]

That is pretty lame

 

[lo4th]

The screws look like they have some corrosion on them.

 

[lo4th]

Ok so here is one hell of a question. I cleaned the screws and it fires perfectly now on my provari v1....however it gets OP on my v2

 

[lo4th]

No one has any idea?

 

[urquidezj]

might be something wrong with the connector, look at that.