Burnt taste on new tank and e-juice

[ShytBrix]

Hey guys I'm kinda new to vaping and I recently got the aspire nautilus tank and innokin MVP20W with Gemini Adam & Eve juice, after setting everything up for a test run I fired it up on the lowest settings 6.0 watts and 3.3 volts but I'm getting a bit of a burnt taste, I've also waited a few minutes for the juice to sit for a bit. Is there something I'm doing wrong or is there a specific wattage or voltage I should be using? Thanks in advance.

 

[CampbellMC]

I generally run my nautilus between 8.5-9W. The coils can take a bit to soak sometimes, so a good tip is when you put a new coil in, put a few drops right into the coil before you screw it onto the glass. Wait a minute, do a couple cold draws (no power), and then puff away. Unfortunately if you dry burned it too much already, you won't get rid of that burnt taste until you replace the coil.

 

[Susan~S]

Hello and welcome to the forum. Glad to have you here!

I go a step further than CambellMC with regards to priming the coils. I add enough juice to the coil (and let it soak in) so that the juice is just barely below the screen.