Buy a mod newbie

Status
Not open for further replies.

bobflanders86

Senior Member
Sep 23, 2014
144
28
Denton Texas
I don't like the touch fire button that can stick on, if your finger is sweaty or wet.(at least it has a side push button) I don't like how fragile the screws are. (at least it comes with extra screws) Your not suppose to charge and vape but you can with this. I want pass through, and I want the manual to say it's ok. If you tap the device the battery can come out and reset the device, that seems annoying. For those who have the ipv2 and had it awhile, are the little cons a nagging annoyance you deal with, or are the problems not everyones experience?
 
I'm relatively new to vaping, got laid up for a surgery and it hurt too much to go outside to smoke so I switched to vapor and haven't really looked back... While I was laid up I did a lot of youtubing on vaping and researched mods. So with little experience and too much knowledge I decided to get a kayfun (Russian 91 v2) and an E-LVT 2.0... Love the kayfun so far (building coils and learning about electricity is fun) and I get my ELVT 2.0 (30watts! and an American chip to boot) tomorrow so I will let you know how it goes.

Started with a itaste vv and a protank 2... cotton is soo much better imo than silica.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread