Buzz ecigg shorted and melted the plastic wrap on batteries

Status
Not open for further replies.

sachavaca

Super Member
ECF Veteran
Jan 12, 2011
994
892
west coast
I would not purchase another buzz. had 1 and the top cap srew loosened up after changing attys a few times. ejuice ran down the inside of it, also the button was not easy to push after minimal usage (flush with the face of tube). I returned it to get it repaired correctly while under warranty. They were supper fast at returning it but nothing had been fixed. still full of ejuice and switch still sucked, well I tried using it anyway and it worked for short bit then stopped. (same as before)
I set it on my desk continuing to work and brushed up against it, it was smoking hot!!!!. burned my fingers removing the battery cap. I am lucky it did'nt burn the place down. I do not recommend leaving batterys in while un-attended. Buy a mod that sealed so no ejuice can enter inside the tube!!!

IF YOU OWN ONE MAKE SURE THE SCREW IN THE TOP CAP IS TIGHT
 

sachavaca

Super Member
ECF Veteran
Jan 12, 2011
994
892
west coast
or you could just take a paper towell and clean the juice out of the top, and make sure to keep the top cap screwed on and stop blaming notcigs for your own mistake.

Just to be clear, The screw inside the atty connection loosened on it's own and I was not aware this could happen!!!!!!. Pherhaps they should have disclosed that info and I would have taken the neccesary precautions to ensure it could not happen by purchasing a 510 extension and a atty shield. Cleaning the top is hardly going to fix the problem since the ejuice is throughout the inside of tube causing electronic components to short out. That is why I returned it for RMA so it could be repaired by a qualified tec, which was not done so I am not satisfied nor will I be unless they step up and fix it like they should have the first time I returned it.
 

Ruppy

Ultra Member
ECF Veteran
Dec 1, 2010
2,972
3,439
WV
Just to be clear, The screw inside the atty connection loosened on it's own and I was not aware this could happen!!!!!!. Pherhaps they should have disclosed that info and I would have taken the neccesary precautions to ensure it could not happen by purchasing a 510 extension and a atty shield. Cleaning the top is hardly going to fix the problem since the ejuice is throughout the inside of tube causing electronic components to short out. That is why I returned it for RMA so it could be repaired by a qualified tec, which was not done so I am not satisfied nor will I be unless they step up and fix it like they should have the first time I returned it.

I guarantee Mike at notcigs will make it right with you. Hes a standup guy and backs his stuff 100%. Definitely post over in the notcigs forum or shoot him a email.
 
Status
Not open for further replies.

Users who are viewing this thread