Buzz pro "freaking out"

[SirPluto]

Well I bought a buzz pro about 2 months ago and have been absolutely loving it!!!! Well today I wasn't getting as good of a hit off of my buzz pro as I normally do. When I looked inside at the LEDs and the blue led is "strobing" whenever I push the button. Tried switching out batteries and it didn't make any difference. I'm kind of at a loss of what to do, any suggestions would be greatly appreciated.

 

[BuzzKill]

Are you using a LR atty ??? if so turn it down just a hair .

 

[SirPluto]

Nope I'm not using a lr atty. I'm using ce2s at 2.8-3.0 ohms. It does this flickering even if there isn't an atty or cartomizer on there.

 

[Bovinia]

Have you had any leaking from your cartos? Try taking a paper towel and cleaning out your top cap connection and see if that helps any.

 

[BuzzKill]

It might be a loose ground wire ? the one on the side , try to tighten it and see if that helps /.

 

[5cardstud]

Also tighten both caps and if that don't work try the old alcohol bath. You may have liquid inside it.

 

[SirPluto]

I'm going to send it in to have it looked at this week. In the mean time I'm gunna buy another bp. I love them and its never a bad thing to have a backup. Will see what buzzkill says. Hopefully its something simple.