Can you dual coil an AGA-T2

[xbrico]

Hello all,

Well, got the new kit fever...so as well as grabbing 2 pro tanks I thought I would get a T2 (or 2) to get into rba stuff and try SS wicks, etc. So far i think I getting better flavour from my T2 on silica with a U-Wick (forgot to bring my blowtorch to work with me to oxidize the mesh!!! :/) than I am with the Protank. But, now that I have the T2 in front of me, I am thinking, can this thing be run dual coil and has anyone done it yet? The face there is the -ve screw flat on the base and the raised -ve tower on the opposite side I am wondering can you run a coil per side? I have attached a few picks of how its setup (apologies for the mess, my VERY 1st gennie wick and coil - at least it worked 1st time @ 1.3ohm!!! ).

I am thinking if the part of the wick closest to the raised -ve was drug a bit away from it, they could essentially look the same on either side.

 

[bradwinters]

I can't open the picks on this phone but yes... The agat2 can be setup as a dual coil. However, you would probably want to drill an extra air hole for the second coil, and then if you ever want to use it again as a single coil setup it won't be optimal as half of your airflow would essentially be wasted. Also, depending on the mod you have it on, like I said I can't open the pictures, it may not fire if the resistance is too low. If you wrap 2 1.3ohm coils the resulting resistance will be around .7ohms which won't fire on a vamo or pretty much any other device that has the 33.33hz chip in it.

 

[DurrtyMethodz]

on my aga-t2 im running 2 SS mesh wicks on a 29 gauge kanthal. 5 wraps on both wicks... right now its putting out about 1.3-1.5 ohms. which is perfect for me since i dont have a mech mod to push sub ohm coils.

 

[xbrico]

Device is an eVic with the 2600mAh 18650 battery in it (standard Samsung that comes with). Current consumables I have is some 400&500 grade ss mesh. 0.3 and 0.4x0.1mm Kanthal A-1 ribbon wire and 3mm silica. Currently my juices are standard 80/20PG mixes (tempted to begin self-mixing some 50/50 stuff). The pics show a 3mm silica running in a U-config (500 ss mesh bootlaces to help feed the silica and stop the frayed ends becoming part of the juice) with I think 3-4 spaced wraps of the 0.3x0.1mm kanthal giving me 1.3ohm (again, 1st ever wick setup so a bit of practice should allow me to get more wraps, and use the broader wire to keep res down below 2).

Don't know what the device is really capable of yet... don't want to change too much stuff (by blowing up me kit!!!) or her indoors will know I been buying a swathe of new bits and bobs and I only got one proper vape device so cant go with it being out of commission!!! My 5yr old noticed instantly, luckily his ma was no where near when he near dropped me in it!!!

Any recommendations for the setup - really dont fancy drilling the top cap out though as right now, the draw is bang on [for me] at stock? Its all about the flavour...if that sings for me, i'll be happy....suppose big puffs of vape would be nice too...sitting in work looking like the Hogwarts Express would do the job nicely.