Can you put the coils in with the rda on the mod?

If I build on a regulated I turn off the mod leaving batteries in. I normally build on Coil Master 521 tab though. Either or is fine.

 

Turn the device off, or risk a accidental push of the fire button which if you are touching the coil, it will burn.

 

What you have seen are probably just RDA stands. Useful if you own more than one RDA.

 

I build on my mods (regulated only) all the time as it's very convenient. I have been known to occasionally hit the fire button by accident, usually while pulling fresh Rayon through the coils...

Just too lazy to turn the mod off or lock it.

 

Couple weeks ago I was wicking here at work and forgot to turn the Detonator off. That fire button reminded me at the first turn.

 

My favorite is getting the thumbnail against one edge of the coil to pull the Rayon through and accidentally hit the button with the other hand that is holding tension on the wick.

Keeps me humble.

 

I have burned a nail or two over the years, irks me more than burning my skin.

 

You’re not alone. My last was screwing a mesh RDA onto the Reload squonker which has a hair trigger fire button. Ended up with a nice waffle grid burn on my finger…and to make matters worse, it was just freshly wicked but not juiced up yet! Love the smell of burnt flesh and cotton in the morning…..smells like, hurt!

 

Another half pound of cotton bacon later...

 

Take a look at these guys.



link

 

I like winding coils on my Drok 510 ohm tester.

 

A few years ago I was cleaning/dry burning a coil and blowing on it to cool it down. My arm slipped and I ended up burning my lip...OUCH, followed by many, many choice words at very LOUD levels. That hurt for some time. Silly me!!! Not a single burn since (shouldn't have said that...Murphy's Law).

 

Exactly what I use except mine is labeled Teika. I wonder how many ohm testers like this are out there just with different names on them. Seen quite a few.

 

I learned early on that just because the glow disappears after a dry burn, that doesn't mean it won't burn your finger. It only took once to learn that lesson.

 

They can probably be traced back to one Chinese factory. I read an article once that talked about how lots of product goes out the back door during third shift in Chinese factories. The employees have some side businesses going on. Those items hit the market under untraceable business names and show up later on various sites. They are particularly hot on high end sports shoes and equipment.

 

I use the coil master 510 tab or a mod depending on how many I’m building