Cartos and Mods

[ibytoohi]

I've been vaping for 10 months and after the usual initial confusion and money flush, my Riva has served me very well. I now have a VV Foxy Box Mod on its way and I plan to try vaping at 4, 5, and 6 volts. I've been using 1.7 LR Ressurectors and Boge 2.0" from CCV. Can I stick with these or would I get a great improvement in vapor production, throat hit, and draw by going to a higher resistance carto? I'm not too keen on dual coils due to leaking and juice sucking.

Also, never used a tank before. Is that a viable alternative with improved TH etc? If so, what kind and vendor recommendations please.

Please keep replies to 3000 words or less.

 

[Scottinboca]

My dual coils don't leak. BTW I love my VV Foxy Box Mod. I've had it for a few months now and it never leaves my side.

 

[TomC]

I bought an inexpensive tube mod at Parkes Vaping just to try out high voltage. I tried one of my 1.7 cartos from CCV at 6+ volts and sparks flew and the carto is now fried. At 6 volts I wouldn't go below 3.0. I bought a single 4.5 and a 5.0 and they both work well at 6 volts.

 

[yo vapo]

I'm using a Boge 2 ohm carto in a tank attached to a VV kit which I made some mistake on such that I'm getting a reading of 6.5 volts at all settings. I'm getting massive amounts of warm vapor, and so far nothing has blown up yet; I expect the carto's coil to pop at any time though. About 4 hours of this so far and all is good...

I'm only using the Boge 2.0 because that's what I had set up in a full tank at the time I finished building the kit. Figured I'd let it play out and see what happens.