- Status
Cartomizers suck. That's your answer for all the above. lol, I kid I kid. I always have trouble with them though, and I never liked them even when they did work well.
3.2 ohms is high and best suited for 5v devices or higher. Juice is your mouth could in fact be related to this. The coil might not be getting hot enough to vaporize the liquid efficiently.
3.2 ohms is high and best suited for 5v devices or higher. Juice is your mouth could in fact be related to this. The coil might not be getting hot enough to vaporize the liquid efficiently.
My theory is if it works, don't fix it.
Just curious. Where did you get them and what ohm were they advertised as?
I got them from vapor solutions: no ohm advertised...
CE2 Clearomizers (Empty) (5/pack)
I just tried double stacking the "donut stopper" - still got juice argggg
CE2 Clearomizers (Empty) (5/pack)
I just tried double stacking the "donut stopper" - still got juice argggg
Yeah - I suppose you are right on the price comparison. I sometimes forget that bit
If I do end up going through all my CE2's I'm going to switch a drip setup.
An Atty lasts me a few months at least so not as disposable and no filler or anything they have a consistant flavor vapour and throat hit
Sent from my Nexus S using Tapatalk
Which atty model is good for dripping? And which tip is recommended? I've seen them but never actually took note of it... I'm going to order one anyways... 510 threading
The only carto that IV liked is the bloog or volt, and they are sttarting to really lack now that I've been on em for a couple weeks
Ha ha ill say it again get urself an Atty
Sent from my Nexus S using Tapatalk
Ha ha ill say it again get urself an Atty
Sent from my Nexus S using Tapatalk
Either get Cisco lr306 withxl driptip from happyvaper or grab a LR ikenvape from mlv. Either 510 or 306. I prefer Cisco these two are your best bet trust me
Sent from my Nexus S using Tapatalk
I have not used this particular brand but the Gotvapes fluxomizers should be close. Clean it. Especially with chocolate flavors. One of my favorite flavors is chocolate hazelnut tobacco but it gums up the coils. Very easy to clean, pull the tube, rinse the wicks and tube under hot water, dab the wicks dry with paper towel. Then dry burn the coils, 5 seconds at a time till you can see the coils glow and the debris turns white. I usually clean mine at least once a day often twice and am averaging about 3-4 weeks on one before the wick breaks or the coil distorts.
Lower ohms does help.
Do yourself a favor and Never buy a Carto or Atty unless you know the ohms. It might work but the next time you buy one you could get something different.
You can't compare ohms for an atty with ohms for a CE2. Their two different aninmals.
Trust me on this one. You hit a 1.5ohm CE2 on a 3.7volt device and it is going to taste like burnt Marshmallows On A Stick minus the Stick.
Lol ya my ce2 were 2,8 ibelieve my advice goes for. An Atty then, guess that's why there not available in lr
Sent from my Nexus S using Tapatalk
Cisco lr306 - do I need to get a special thread adapter for my 510 battery? What/whois MLV?
no a 306 is a 510 thread , no adapter needed just grap a derlin xl drip tip if u use an ego cone cause the reg size one isnt long enough , id get the 1.8 ohm one and make sure u get cisco not joye
Sorry I didn't update yesterday - I did pull the CE2 apart to clean though. So the rubber stopper that sits directly on top of the wick... was burnt! ON BOTH CE2's! I thought at first it was build up... but I scrubbed the bejeezus out of it and still black... So this time I set it a little bit higher than the wick...
Moving forward I'm only going to use clear liquids in the CE2. I've been vaping Mild Blue and it seems to be functioning better in the long run.
Moving forward I'm only going to use clear liquids in the CE2. I've been vaping Mild Blue and it seems to be functioning better in the long run.
You must have some Old CE2's because the "Cup Seal" and the O-Ring have been made out of Black Rubber for quite some time.
yeah... maybe... these are white. Ohwell... after the clean my clear juice is back to dark... I'm going to get a drip tip and the next CE2's I'm going to order from the US.
Yeah the ones that Xslor is using are the old ones.
That rubber cup that sits on the ceramic cup will almost always get burn on the inner inside. You can try and "trim" some of that out to prevent it from burning.
That rubber cup that sits on the ceramic cup will almost always get burn on the inner inside. You can try and "trim" some of that out to prevent it from burning.
- Status
Similar threads
