CE2 O-ring replacement?

[Herculicia]

I purchased some CE2's from gotvapes and when they arrived I noticed none had the o-ring seal. So I e-mailed them and was told that anymore they're shipped without it because the rubber tip should prevent any juice from leaking. Wrong! I'd like to order some o-rings online, but I'm not sure what material is best to use for this purpose. I figure a 3/8 OD with a 1/4 ID would work okay. Has anyone replaced the seals and where did you get them?

Thanks!

 

[jj2]

Must remember not to order from there because they are needed!!!
As for what material is best, I don't have the slightest idea but am interested in the answer.

 

[TuErOs]

I believe ce2's up to version 4 had o-rings but any version after 4 don't have o-rings. Someone correct me if i'm wrong.

 

[AlmightyGod]

I believe ce2's up to version 4 had o-rings but any version after 4 don't have o-rings. Someone correct me if i'm wrong.

Version 4 is the final version of the CE2. There is no version 5, unless you want to call the Clearomizer that.

 

[Toot Sweet]

Send them back. I can't imagine why they would have made that change.

 

[juicefreak]

it's just a silicone ring. you could try faucet 0-rings from a hardware store, but i've found the KR808d inner ring fits just fine. even the ceramic cup cover in a CE2 is just an 808d inner ring with 2 slits cut in the sides for the wick

 

[Toot Sweet]

Version 4 is the final version of the CE2. There is no version 5, unless you want to call the Clearomizer that.

hmm, nhaler has a V5 clearomizer for sale, although the picture and description indicate silicone seals are present since an included syringe tip would be moot without the seal.

 

[Herculicia]

They still have the seal over the atomizer with the channels for the syringe and the white rubber cap on the end, just no middle clear o-ring. And after looking at the nhaler link, it doesn't look like those have it either!

 

[tony2stix]

Hi all is there any where I can buy the silicone ring from the center of a 510 battery connector thanks
Tony2

 

[mwa102464]

the tube size is the same as a 510 so why not just take the silicone O-Ring out of a regular 510 or even a KR8 and slam it in the CE2 it will work with no problem, it doesn't have to even seat down in the ceramic dish because it will wick better without being put all the way down. just my 2c, Chris and Danno are some nice guys also, if you really want them just ask them again if they could dig you a few up and I'm sure they can