I know its been done before, but just thought I would share what I did today. Pics are pretty self-explanatory.
1. Remove the CE2 from its outer shell.
2. Mark where the outer shell will sit inside the tank.
3. Cut the tank out with a Dremel.
4. Reinsert the CE2 into the newly slotted tube.
5. Remove the top cap and fill by dripping down the side of the tank tube to fill.
6. Re-install the top delrin cap.
7. Let sit for about twenty minutes so that the wicks get saturated.
8. Insert your favorite drip tip and vape to your hearts content.
Overall, this is my first experience with CE2s....ehh....I really don't care for them. They really can't seem to keep up with me. They are wicking just fine, but about every 3 or 4th hit I start to get a somewhat dry hit. I know, I know....you have to tilt them and all, but as pbusardo likes to say "they are just a little to fiddly".
View attachment 88946 View attachment 88947 View attachment 88948 View attachment 88949
1. Remove the CE2 from its outer shell.
2. Mark where the outer shell will sit inside the tank.
3. Cut the tank out with a Dremel.
4. Reinsert the CE2 into the newly slotted tube.
5. Remove the top cap and fill by dripping down the side of the tank tube to fill.
6. Re-install the top delrin cap.
7. Let sit for about twenty minutes so that the wicks get saturated.
8. Insert your favorite drip tip and vape to your hearts content.
Overall, this is my first experience with CE2s....ehh....I really don't care for them. They really can't seem to keep up with me. They are wicking just fine, but about every 3 or 4th hit I start to get a somewhat dry hit. I know, I know....you have to tilt them and all, but as pbusardo likes to say "they are just a little to fiddly".
View attachment 88946 View attachment 88947 View attachment 88948 View attachment 88949